Install:OpenLiteSpeed with SPDY Installation Notes

From OpenLiteSpeed Wiki

Revision as of 13:54, 19 June 2013 by Lsong (talk | contribs) (OpenSSL 1.0.1)

Enabling SPDY

SPDY is disabled by default. To enable SPDY, before installation, run the configure script in the OpenLiteSpeed installation directory with the following option:

./configure --enable-spdy

OpenSSL 1.0.1

SPDY requires OpenSSL 1.0.1 or higher. If your system does not have a high enough version of OpenSSL, it can be downloaded from the OpenSSL site.

Upgrading OpenSSL can cause problems in your system, so it is not recommended to replace your current version of OpenSSL if you have a version lower than 1.0.1. Instead, we recommend that you install OpenSSL in a separate directory where it can be used specifically for OpenLiteSpeed. You can then direct OpenLiteSpeed to this directory during installation of OpenLiteSpeed 1.1.

./config --prefix=/usr/local --openssldir=/usr/local/openssl
make install

The above series of commands directs OpenLiteSpeed to look for the copy of OpenSSL in /usr/local/. You can customize this to wherever you wish.