Install:OpenLiteSpeed with SPDY Installation Notes
From OpenLiteSpeed Wiki
Revision as of 22:10, 13 December 2017 by Malegre (Removed Help Category.)
When compiled from source, OpenLiteSpeed does not have SPDY support compiled by default. SPDY support must be specifically enabled when compiling.
Compiling SPDY requires OpenSSL 1.0.1 or higher. Many, but not all, operating systems come with a high enough version of OpenSSL. (Specifically, CentOS 5 is shipped with OpenSSL 0.9.8.) This wiki will take you through the steps for checking your OpenSSL version, installing a newer version (if necessary), and compiling OpenLiteSpeed with SPDY.
If you install OpenLiteSpeed from one of our repositories, SPDY will be compiled and enabled (and can be used) by default, even if you have CentOS 5.
Check OpenSSL version
You can check your current OpenSSL version by running the command
Install OpenSSL 1.0.1
If your system does not have a high enough version of OpenSSL, it can be downloaded from the OpenSSL site.
Upgrading OpenSSL can cause problems in your system, so it is not recommended to replace your current version of OpenSSL if you have a version lower than 1.0.1. Instead, we recommend that you install OpenSSL in a separate directory where it can be used specifically for compiling OpenLiteSpeed. You need to be careful when doing this so that OpenLiteSpeed will be able to find all the files it needs when installing. Use the following steps:
- Download and unpack a newer version of OpenSSL from the OpenSSL site.
- From inside the unpacked package, run the commands:
./config --prefix=/usr/local --openssldir=/usr/local/openssl make make install
/usr/localis the path to your new OpenSSL directory and
/usr/local/opensslis the name of your new OpenSSL directory. You can put your new version of OpenSSL wherever you want, but you need to stipulate the directory name and name it
oppenssl. This is how OpenLiteSpeed will know where to look for the right files.
Install OpenLiteSpeed with SPDY enabled
When building OpenLiteSpeed, use the
--enable-spdy option to build OpenLiteSpeed with SPDY enabled. When building with SPDY enabled, you must stipulate where your installation of OpenSSL is using the
--with-openssl configuration option shown below:
./configure --with-openssl=/usr --enable-spdy make make install
Note: The default OpenSSL location is
/usr. If you installed another copy of OpenSSL in a different directory (such as in
/usr/local, as directed above), be sure to direct OpenLiteSpeed to look for OpenSSL in the correct directory.
Once SPDY support has been built in, you turn on SPDY using the Enable SPDY setting in the Listeners tab of the WebAdmin console (WebAdmin console > Configuration > Listeners > SSL). In this setting, you can enable SPDY/2 and/or SPDY/3 or disable SPDY altogether. All versions are enabled by default.