Actions

Help

Difference between revisions of "Install:OpenLiteSpeed with SPDY Installation Notes"

From OpenLiteSpeed Wiki

Line 14: Line 14:
  
 
== Enabling SPDY ==
 
== Enabling SPDY ==
SPDY is disabled by default. To enable SPDY, before installation, run the configure script in the OpenLiteSpeed installation directory with the following option:
 
<blockquote><code>./configure --enable-spdy</code></blockquote>
 
  
 +
SPDY module is not compiled in by default.
 +
 +
To add SPDY support, you need to add the configure option <code> --enable-spdy</code> and run the configure script and build a new binary.
 +
 +
Once SPDY module is built in, you can use "Enable SPDY" setting from WebAdmin Listener - SSL configuration tab. You can specify enable SPDY/2 or SPDY/3 or disable SPDY. Default is enable both SPDY/2 and SPDY/3.
  
  
  
 
[[Category:Help]]
 
[[Category:Help]]

Revision as of 14:13, 19 June 2013

Install OpenSSL 1.0.1

SPDY requires OpenSSL 1.0.1 or higher. If your system does not have a high enough version of OpenSSL, it can be downloaded from the OpenSSL site. For CentOS 5 & CentOS 6 users, you need to manually install OpenSSL 1.0.1.

Upgrading OpenSSL can cause problems in your system, so it is not recommended to replace your current version of OpenSSL if you have a version lower than 1.0.1. Instead, we recommend that you install OpenSSL in a separate directory where it can be used specifically for OpenLiteSpeed. You can then direct OpenLiteSpeed to this directory during installation of OpenLiteSpeed 1.1.

cd openssl-1.0.1e
./config --prefix=/usr/local --openssldir=/usr/local/openssl
make
make install

The above series of commands directs OpenLiteSpeed to look for the copy of OpenSSL in /usr/local/. You can customize this to wherever you wish.

Enabling SPDY

SPDY module is not compiled in by default.

To add SPDY support, you need to add the configure option --enable-spdy and run the configure script and build a new binary.

Once SPDY module is built in, you can use "Enable SPDY" setting from WebAdmin Listener - SSL configuration tab. You can specify enable SPDY/2 or SPDY/3 or disable SPDY. Default is enable both SPDY/2 and SPDY/3.